Need help with XBEE network

hey guys,
i'm pyrotechnician , built digital firing system controlled via pc serial interface. system works on rs485 network @ moment i'd add wireless functionality well.

the reason need i'd @ least 1 of modules able act both master , slave. network work this:
                   [mod1]                                                             [mod2]
               /                                                                         /
[master]  - [mod2]                 this:      [mod1] - [mod3]           without reconfiguration.
               \                                                                         \
                   [mod3]                                                             [mod4]

the [mod1] in case have display , interface if code implemented code, matter of switch module master slave via interface. ideally, i'd work master time receive instructions master. guess question is, possible? i'm assuming i'll need use s2 xbee modules.

cheers.

if using series 2 xbees, each configured coordinator or router/end device. typically, use router, more devices can added, if don't want 1 forward packets, configure end device.

your concept of master listens master flawed. why xbee have listen itself? knows going send, doesn't make sense need listen itself.

Arduino Forum > Using Arduino > Networking, Protocols, and Devices (Moderator: fabioc84) > Need help with XBEE network

arduino